Grizzly G0801 Owner's Manual page 7

Table Controls
I
P
O
N
Figure 3. Table control handwheels and X-axis
locks.
Q
R
Figure 4. Knee and cross slide locks, and one-
shot oiler.
Model G0801/G0802 (Mfd. Since 09/15)
J
K
L
M
S
I. X-Axis Handwheel (1 of 2): Manually moves
table along X-axis (left and right).
J. X-Axis Locks: Tighten to prevent X-axis
table movement for increased rigidity during
operations when the X-axis should not move.
K. Power ON/OFF Switch: Turns machine ON
and OFF.
Note: Front panel of switch contains Stop
button only. Lift panel to access ON button,
then leave panel in "down" position during
use.
L. Spindle Direction Switch: Changes direc-
tion of spindle rotation.
M. Graduated Collar (Y-Axis): Displays Y-axis
table movement in 0.001" increments. One
full revolution represents 0.100" of table
travel.
N. Y-Axis Handwheel: Manually moves table
along Y-axis (front and back).
O. Knee Crank: Manually moves table along
Z-axis (up and down).
P. Graduated Collar (X-Axis): Displays X-axis
table movement in 0.001" increments. One
full revolution represents 0.100" of table
travel.
Q. One-Shot Oiler: Lubricates table ways.
R. Z-Axis Lock: Tightens to prevent Z-axis
table movement for increased rigidity during
operations when the Z-axis should not move.
S. Y-Axis Lock: Tightens to prevent Y-axis
table movement for increased rigidity during
operations when the Y-axis should not move.
-5-