Associating A Modem With A Port - Lucent Technologies PortMaster 4 Configuration Manual

Table 9-1
Modem Name Modem Name
(Short) (Long)
usr-v32-p USR
Courier/Sportster
V.32bis PCMCIA
usr-v34-p USR
Courier/Sportster
V.34 PCMCIA
usr-v32 USR
Courier/Sportster
V.32bis
usr-v34 USR
Courier/Sportster
V.34
usr-spt-v32 USR Sportster
V.32bis
usr-spt-336 USR Sportster 33.6
zyxel Zyxel U1496E

Associating a Modem with a Port

To automatically configure a modem and associate it in the modem table with the port
it is attached to, use the following commands:
Command> set C0|all modem-type ModemName(short)
Command> reset C0|all
For example; to associate a U.S. Robotics V.34 modem with port C0 and configure the
modem, enter the following commands:
Command> set C0 modem-type usr-v34
Command> reset C0
To configure all ports for the same modem type, use all instead of the port number in
the previous example. After the modem is attached to the port, configure the other
modem settings described in "Configuring Ports for Modem Use" on page 9-5.
To configure the modem not to answer when users dial in, set C0=0 in the initialization
string.
Configuring Ports for Modem Use
The modem settings described in this section are configured for each port and must
match the configuration on the attached modem.
Using External Modems
Factory Default Modem Table Entries (Continued)
DTE
Rate
57600
115200
57600
115200
57600
115200
57600
Configuring Ports for Modem Use
Initialization String
AT&F1&W
AT&F1S0=1&W
AT&F1S0=1&W
AT&F1S0=1&W
AT&F1S0=1S10=20S13.0=1&W0
AT&F1S0=1S10=20S13.0=1&W0
AT&FM0&D2S0=1S2=1
9-5