Adding Users To The User Table; Deleting Users From The User Table; User Types - Lucent Technologies PortMaster 4 Configuration Manual

User Types

To display the current users in the user table, for example, enter the following
command:
Command> show table user
Name
---------------------------------------------------------------------------
jozef
adele
elena
taffy
john
To display configuration information for a particular user, for example, use the following
command:
Command> show user elena
Username:
Address:
Protocol:
MTU:

Adding Users to the User Table

You must add users to the user table before configuring any settings for them. The
username is a string of from 1 to 8 printable, nonspace ASCII characters. The optional
user password is a string of from 0 to 16 printable ASCII characters. You cannot add
users with blank usernames.
To add a login user to the user table, use the following command:
Command> add user Username [password Password]
To add a network user to the user table, use the following command:
Command> add netuser Username [password Password]
Note – To add a network user, you must use the netuser keyword. Thereafter, you can
use either the netuser or the user keyword to configure settings for the network user.
You must always use the user keyword when configuring login users.

Deleting Users from the User Table

To delete a user from the user table, use the following command:
Command> delete user Username
User Types
User settings define the nature and behavior of dial-in users. The user table contains
entries for each defined dial-in user along with the characteristics for the user.
5-2
Type Address/Host
Netuser negotiated
Login User default
Netuser assigned
Login User defaults
Netuser 192.168.7.8
elena Type:
Assigned Netmask:
PPP Options:
1500 Async Map:
Netmask/Service RIP
0000000000
Telnet
255.255.255.255 No
PortMaster
0000000000 No
Dial-in Network User
255.255.255.255
Quiet, compressed
00000000
PortMaster 4 Configuration Guide