Testing Your Location Configuration - Lucent Technologies PortMaster 4 Configuration Manual

Table of Contents

Advertisement

Testing Your Location Configuration

When you are configuring a location, you can set a manual connection for the location
so that you can test the configuration before resetting the connection to on-demand or
automatic. To test the configuration, you must initiate a connection with the remote
location by using the dial command from the command line.
To display the chat script (if you are using one) during dialing, use the optional -x
keyword. You can watch the connection process to ensure that location-specific settings
are configured correctly. This keyword also resets some debugging values previously set
with set debug.
When your location is configured correctly, change the connection type from manual to
automatic or on-demand.
To test your configuration, use the following command:
Command> dial Locname [-x]
Configuring Dial-Out Connections
Testing Your Location Configuration
7-11

Advertisement

Table of Contents
loading

Table of Contents