Troubleshooting Ss7 Configurations - Lucent Technologies PortMaster 4 Configuration Manual

To display configuration information for a specified line, use the following command
and substitute the desired line number:
Command 0> show Line0

Troubleshooting SS7 Configurations

This section provides information on checking activity between the slot on the
PortMaster 4 and the SS7 gateway. To troubleshoot modems, see "Troubleshooting
Digital Modems" on page 10-11.
Checking SS7 Gateway Initialization
Caution – Because debug commands can significantly slow throughput on line boards,
!
Lucent recommends that you do not perform debugging operations on production lines.
To view SS7 debug information for a Quad T1 or Tri E1 board, set the view to the slot
and enter the following commands:
Command 1> set console
Command 1> set debug imt on
For example, the following sample output shows a partial stream of debug messages that
indicate slot 1 activity until the SS7 gateway is completely initialized. The output shows
only "heartbeat" information when the gateway is in a ready state.
slot1: imt_hangup: line(1), slot(23)
slot1: imt_hangup: line(1) slot(23) flags(0) state(1)
slot1: imt_hangup: state 1, done
slot1: imt_hangup: done
slot1: imt_receive_data: got heartbeat
slot1: imt_proc: IMT_HEARTBEAT
slot1: imt_process_heartbeat: sent heartbeat
slot1: imt_send_data: sent packet
slot1:
slot1:
slot1: imt_receive_data: got heartbeat
slot1: imt_proc: IMT_HEARTBEAT
slot1: imt_process_heartbeat: sent heartbeat
Configuring T1, E1, and ISDN PRI
00
00
Configuring SS7
10-23