Changing The Height Of The Table And Stand - JUKI AMS-224EN-4530 Instruction Manuals

3-7. Changing the height of the table and stand

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
The height of the table (measured from the floor to the table) is adjustable to six different heights.
① 870mm ② 897mm ③ 922mm ④ 945mm ⑤ 967mm ⑥ 988mm
It has been factory-adjusted to ② at the time of delivery.
1) Insert the claw of forklift up to the transverse beam A in front of the upper stand from the position as
shown in the figure in the rear of the sewing machine.
2) Lift the claw of the forklift up to the position where the claw of forklift comes in contact with the bot-
tom surface of the upper stand and the upper stand does not fall.
* Take care not to allow the forklift claw to crush the cable.



3) Loosen bolts of ❶ through  .
4) Lift the claw of forklift, release bolts of ❸ , ❾ and  from the regulating grooves, move stands  ,
 and  in the directions of both arrow marks, and lower the claw of forklift at the positions where
the respective groove positions meet with one another.
At this time, make sure that bolts of ❸ , ❾ and  have been securely set in the grooves.
5) Securely tighten bolts of ❶ through  with tightening torque of 45 ± 2 N•m.
A
❼



❽

Regulating grooves
– 8 –
A
❷
❻
❹

❾
❶
❺

❸