Points To Be Applied With Juki Grease B - JUKI AMS-224EN-4530 Instruction Manuals

B
❸

(2) Points to be applied with JUKI Grease B

Use grease tube B (part number: 40013640) (in light violet) supplied with the unit for add-
ing grease to any points other than the points specified below. If any grease other than
the specified one is used, the related components can be damaged.
■ Grease supplement to the face plate section
❹
❶
❷
❻
❼
❽
A


❸
❺
– 112 –
1. Do not wipe off the grease ap-
plied onto the periphery of needle
bar inside the frame. If the grease
has decreased due to cleaning,
air blow or other reasons, apply
grease again without exceptions.
2. When operating the sewing ma-
chine, turn the needle bar upper
bushing grease cover in direction
B to close grease inlet  .
3. The rear face of the needle bar
crank rod has projection  with
a sharp edge. So, care should
be taken to the projection. Never
put your finger to the rear face of
the needle bar crank rod during
greasing procedure.
1) Open the face plate cover.
2) Add the JUKI Grease B onto the felt sections
(3 locations), peripheral shoulder screw, ful-
crums ❶ to ❼ and guide groove section ❽ .