JUKI AMS-224EN-4530 Instruction Manuals page 90

No.
Counter motion selection
Sewing counter
Height of eight of presser at the time
of 2 step stroke
Buzzer sound can be prohibited.
Without buzzer sound Panel operating sound Panel operating sound + error
Number of stitches
of thread clamp release is set.
Clamping timing
of thread clamp can be delayed.
Thread clamp control can be prohibited.
Normal
Feed motion timing is selected.
Set the timing in "–" direction when stitch is not
well-tightened.
State of the presser after end of sewing is selected.
Presser goes up
a f t e r m o v i n g a t
start of sewing.
Presser goes up
by pedal operation
a f t e r m o v i n g a t
start of sewing.
Presser lifting motion at the end of sewing can be set.
With presser up
Origin retrieval can be performed every time after end of
sewing (other than combination sewing)
Without origin retrieval
Origin retrieval in combination sewing can be set.
Without origin
retrieval
Item
No. of pcs. counter Bobbin counter
Prohibited
Presser goes up immediately after end of sewing.
The presser foot moves to the sewing starting point,
then goes up with the presser foot lifting switch.
The sewing machine starts sewing with the
start switch. When the sewing machine stops
midway through sewing, the presser foot goes
up at the preset presser lift position.
Without presser up
With origin retrieval
Every time 1 Every time 1 cycle is
pattern is finished.
– 86 –
Setting range
4530/6030
---
10 to 300
---
1 to 7
－ 10 to 0
---
－ 8 to 16
---
---
---
---
finished.
Edit unit
6060
---
1
---
1
1
---
1
---
---
---
---