JUKI AMS-224EN-4530 Instruction Manuals page 91

No.
State of presser when sewing machine stops by temporary
stop command can be selected.
Presser rise.
* For the PAUSE command, select "UP."
Needle stop position is set.
UP position
Thread trimming can be prohibited.
Normal
Route of return to origin by return to origin button can be selected.
Linear return
Bobbin winding speed can be set.
The wiper can be disabled.
Invalid
Unit of sewing shape size change can be selected.
%input
Thread tension output time when setting
thread tension can be set.
Bend position of thread clamp is selected.
0 : S type
1 : H type thin thread (#50 to #8)
2 : H type intermediate
3 : H type thick thread (#5 to #2)
Thread clamp and thread clamp position selection
Front position
Thread breakage detection selection
Thread breakage
detection invalid
Number of invalid stitches at the start
of sewing of thread breakage detection
Number of invalid stitches during sewing
of thread breakage detection
Item
Presser rise with
presser switch.
Upper dead point
Thread trimming
prohibited
Origin retrieval /
Reverse return of
pattern Sewing start point
Magnet typewiper
Actual size input
Rear position
Thread breakage
detection valid
– 87 –
Setting range
Edit unit
4530/6030 6060
--- ---
--- ---
--- ---
--- ---
800 to 2000 100 sti/min
--- ---
--- ---
0 to 20 1
--- ---
--- ---
--- ---
0 to 15 1 stitch
stitches
0 to 15 1 stitch
stitches