Run Signal - Hitachi X200-002SFE/NFU Instruction Manuals

Run Signal

When the [RUN] signal is selected as an
intelligent output terminal, the inverter
outputs a signal on that terminal when
it is in Run Mode. The output logic is
active low, and is the open collector type
(switch to ground).
Option
Code
00
Valid for inputs:
Required settings
Notes:
• The inverter outputs the [RUN] signal
whenever the inverter output exceeds the start
frequency specified by parameter B082
start frequency is the initial inverter output
frequency when it turns ON.
• The example circuit for terminal [11] drives a
relay coil. Note the use of a diode to prevent the
negative going turn-off spike generated by the
coil from damaging the inverter's output
transistor.
More user manuals on
Terminal
Function Name
Symbol
RUN Run Signal
11, AL0 – AL2
(none)
ManualsBase.com
1
[FW,RV]
0
Output
frequency
1
Run
0
signal
State
ON when inverter is in Run Mode
OFF when inverter is in Stop Mode
Example for terminal [11] (default output
configuration shown – see
Inverter output
terminal circuit
.
The
Example for terminal [AL0], [AL1], [AL2] (requires
output configuration – see
Inverter logic
circuit board
See I/O specs on
B082
start freq.
ON
Description
page 3-54):
RUN
CM2 11
RY
page 4-35 and 3-54):
RUN
AL0 AL1 AL2
Power
Load
supply
page 4-6
4−37
t