Hitachi X200-002SFE/NFU Instruction Manuals page 247

B−20
Note 1:
Note 2:
More user manuals on
Coil
Name
Number
0014h Alarm signal
0015h PID deviation signal
0016h Overload signal
0017h Frequency arrival signal
(set frequency or above)
0018h Frequency arrival signal
(at constant speed)
0019h Run Mode signal
001Ah Data writing
001Bh CRC error
001Ch Overrun error
001Dh Framing error
001Eh Parity error
001Fh Check sum error
ON usually when either the control circuit terminal board or a coil is ON.
Among control circuit terminal board (intelligent input terminals) and coils,
the control circuit terminal board has a high priority. If the master cannot
reset the coil ON status due to a transmission line break, please turn ON and
OFF the control circuit terminal board to make the coil to OFF status.
The content of a transmission error is held until the error is reset. (The error
can be reset while the inverter is running.)
ManualsBase.com
List of Coil Numbers
R/W
R 0...Normal
1...Trip
R 0...OFF
1...ON
R
R
R
R
R 0...Normal status
1...Writing
R 0...No error *2
R 1...Error
R
R
R
Description