Removing/Reinstalling The Cabinet; Battery Sub Panel - Sony BVW-55 Maintenance Manual

1-6. Removing/Reinstalling the Cabinet

This section explains the removal and installation procedures for main parts.
For other mechanical parts, refer to the maintenance manual Part 2 Volume 1.
n
If two VTRs are coupled, remove the handle, joint plates and cables that are docking the VTRs in advance.
As for how to separate, refer to the operation manual supplied with the BVW-55.

1-6-1. Battery Sub Panel

c
The unit is equipped with shielding springs which have sharp edges.
Do not contact them with bare hands. Pay careful attention when servicing.
1. Loosen the four screws fully.
n
Each screw is held by a stop washer. Do not separate the washer from the screw when loosening.
2. Disconnect the two harnesses 1 and 2 from the connectors (CN2, CN3) on the CN-1662 board.
3. Reinstall the battery sub panel in the reverse order of removal.
n
When reinstalling, take care that the harnesses are not caught between the upper frame and battery
sub panel.
Screws
BVW-55
Screws
Battery sub panel
Shielding spring
1-6. Removing/Reinstalling the Cabinet
Harness 1
Battery sub panel
CN2
CN-1662 board
CN3
Harness 2
1-13