Denso RC7M Manual page 16

5. Daily and Periodical
Inspections
6. Management of
Floppy Disks
7. Safety Codes
ANSI/RIA R15.06-1999
ANSI/UL1740: 1998
CAN/CSA Z434-03
ISO10218-1: 2006
NFPA 79: 2002
8. Battery Recycling
(1) Be sure to perform daily and periodical inspections. Before
(2) When carrying out periodical inspections or any repairs,
(1) Carefully handle and store the "Initial settings" floppy disks
(2) After finishing teaching or making any changes, always save
(3) Write the names of each of the floppy disks used for storing
(4) Store the floppy disks where they will not be exposed to dust,
The safety standards relating to robot systems are listed below.
As well as observing the safety precautions given in this manual,
ensure compliance with all local and national safety and
electrical codes for the installation and operation of the robot
system.
Standards
Industrial Robots and Robot Systems--Safety Requirements
Safety for Robots and Robotic Equipment
Industrial Robots and Robot Systems--General Safety Requirements
Robots for industrial environments--Safety requirements--Part 1: Robot
Electrical Standard for Industrial Machinery
DENSO Robot uses lithium batteries.
Discard batteries according to your local and national recycling
law.
starting jobs, always check that there is no problem with the
robot and related equipment. If any problems are found,
take any necessary measures to correct them.
maintain records and keep them for at least 3 years.
packaged with the robot, which store special data exclusively
prepared for your robot.
the programs and data onto floppy disks.
Making back-ups will help you recover if data stored in the
robot controller is lost due to the expired life of the back-up
battery.
task programs to prevent incorrect disks from loading into
the robot controller.
humidity and magnetic field, which could corrupt the disks or
data stored on them.
Title