Denso BHT-1306BWB User Manual page 242

BHT-1300B Series
Message
230
BHT Response
If this error occurs, the
warning tone beeps five
times.
The message is continuously
displayed.
If this error occurs, the
warning tone beeps five
times and then turns itself
off.
The BHT displays this error
message and automatically
runs the execution program
from the point of start-up.
Cause
During execution of
System Program, the
System Program has
received an invalid
command code.
(xxxxxxxx: Error address)
No user programs are
found when the BHT is
turned on.
Any of the hardware
error, memory error,
execution program error,
etc. has occurred.
(XXXX: Error code)
Operation was terminated
without turning OFF the
power normally with the
resume function set, and
therefore resume info has
been lost.
Countermeasure
Unload and reload the
battery cartridge, then turn
the BHT on.
If this error occurs
frequently, make a note of
the displayed message and
codes and contact your
system administrator.
Contact your system
administrator.
You can run the code
scanning demo without user
programs.
Pressing "1:Yes" runs the
code scanning demo.
Press the trigger switch to
start the code scanning
demo. Selecting "2:No" turns
the power off.
Turn the BHT on again. If
this error occurs frequently,
make a note of the displayed
code and contact your
system administrator.
If this error occurs
frequently, make a note of
the displayed code and
contact your system
administrator.