Denso BHT-1306BWB User Manual page 191

5.
Use the cursor keys ([▲] [▼]) or numeric key ([3]) to highlight [3: NUM RESPONSES] and then
press the ENT key.
Entry mode is activated and the cursor is displayed.
6.
Use the numeric keys to enter the desired value.
Set up the number of devices to detect.
This number is used only for the device detection ([1: DO IT] menu).
Valid Range: 0 – 8, Default: 0.
Detects a maximum of 8 devices when "0" is set.
Note that the setting specified here will not be saved.
To delete a single character, press and hold the BS/C key. To delete the entire entry, press and hold the
BS/C key or press the SF and BS/C keys simultaneously.
7.
Press the ENT key.
8.
Use the cursor keys ([▲] [▼]) or numeric key ([1]) to highlight
[1: DO IT] and then press the ENT key.
The screen on the right is displayed and the device detection is started.
The device inquiry ends and the screen on the right is displayed when;
・ The specified number of devices have been found.
・ The specified time has elapsed.
・ The BS/C key has been pressed while detecting devices.
Press and hold the BS/C key to return to the BROWSE DEVICE menu.
To set the detected device address as a destination remote device address
for the master station, use the cursor keys ([▲] [▼]) or numeric keys to
select the desired address and then press the ENT key.
Barcode Handy Terminal
179