Setting The Communication Environment - Denso BHT-1306BWB User Manual

BHT-1300B series

[5] Setting the communication environment

The communication environment settings following system initialization are follows.
Do not change these settings unless necessary.
Interface to be used
Communication protocol
Infrared interface port
TRANSMIT SPEED
PROTOCOL
USB interface port
PROTOCOL
Use the following procedure if necessary to change the communication environment settings.
1.
Select "5: COMMUNICATION" at the SET SYSTEM menu and then
press the ENT key.
The SET COMMUNICATION menu screen on the right is displayed.
2.
Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2]) to highlight
the item to be set and press the ENT key.
"1: COM1":
Changes the cradle (CU) or IrDA communication parameter settings.
"2: COM2":
Change the USB communication parameter settings.
"3: COM PORT:
Changes the USB communication parameter settings.
4: PROTOCOL TYPE:
Changes the communication protocol settings.
5: OPEN "COM:" DETAIL:
Changes the communication conditions used by the user program (OPEN "COM:") developed with
BHT-BASIC.
Refer to the following section for details of the above items.
Press and hold the BS/C key to return to the SYSTEM MENU.
100
Item
COM1 (Communication with the CU)
Ymodem protocol
Baud rate 115200 bps
Protocol options SERIAL No.:
H. PARITY:
LINKUP TIME:
FIELD SPACE:
Protocol options SERIAL No.:
H. PARITY:
LINKUP TIME:
FIELD SPACE:
Default
ON (Adds serial numbers to data
blocks.)
ON (Adds horizontal parity.)
30 seconds
Ignore (Trim)
ON (Adds serial numbers to data
blocks.)
ON (Adds horizontal parity.)
30 seconds
Ignore (Trim)
SET SERIAL PORT
1：COM1
2：COM2
3：COM PORT
4：PROTOCOL TYPE
5：OPEN"COM："DETAIL