Table of Contents
Advertisement
im Vertrieb von
Switching power to receptacles on and off
Grouping receptacles
www.camboard.de
CAMBOARD Electronics
Switching/Grouping screen
To turn power to receptacles on and off:
1.
On the Configuration tab, select Switching/Grouping from the side-bar
menu.
2.
In the Power column, select the On or Off radio button beside the number of
each receptacle that you want to switch. If you want to switch a group of
receptacles, select On or Off for one of the receptacles in that group. (See
Grouping receptacles, below.)
3.
Click Submit to put your changes into effect.
If you turn power on by pressing the receptacle button on the front panel
while this screen is displayed, the screen does not change to reflect your
actions until you click Refresh.
You may want to group two or more receptacles together to ensure that they are
switched on or off at the same time. You can create up to three groups. To group
receptacles, follow these steps:
1.
Locate the number of the first receptacle that you want to group.
2.
In the Group Number column, select the radio button for the group number
(1, 2, or 3) to which you want to assign the receptacle.
3.
Repeat steps 1 and 2 for the rest of the receptacles that you want to group
with the first one.
4.
When you have made all desired grouping selections, click Submit.
After receptacles have been grouped, any power selection that you make for
one of the grouped receptacles is also performed on the others in that group
when you click Submit.
If you do not want to group a receptacle with any others, select None for it.
Tel. 07131 911201
IPL T PCS4 • Web Page-Based Setup and Control
Fax 07131 911203
ce-info@camboard.de
4-15
Advertisement
Table of Contents
