Table of Contents
Advertisement
im Vertrieb von
Front Panel Features and Operation, cont'd
Mode 4
Activation — Hold the Reset button in until the Power LED blinks twice (about
Result — Reset mode 4 does the following:
Purpose and notes — Mode 4 enables you to set IP address information using
Mode 5
Activation — Hold in the Reset button until the Power LED blinks three times
Result — Performs a complete reset to factory defaults (except for the firmware).
Purpose and notes — Mode 5 is useful if you want to start over with control
www.camboard.de
3-8
IPL T PCS4 • Front Panel Features and Operation
CAMBOARD Electronics
six seconds). Release it, then immediately press it again briefly (for less
than one second). The Power LED blinks four times in quick succession,
confirming a mode 4 reset.
Nothing happens if the brief press does not occur within one second.
•
Enables ARP program capability.
•
Sets IP back to factory IP settings.
•
Sets Subnet back to factory default.
•
Sets Gateway back to factory default.
•
Sets port mapping back to factory default.
•
Turns DHCP off.
•
Turns events off.
ARP and the MAC address.
(about nine seconds). Release it, then immediately press it again briefly (for
less than one second). The power LED blinks four times in quick
succession, confirming a mode 5 reset.
Nothing happens if the brief press does not occur within one second.
software configuration and to replace events.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de
Advertisement
Table of Contents
