Table of Contents
Advertisement
im Vertrieb von
Web Page-Based Setup and Control, cont'd
Configuration
There are seven Configuration Web pages, which only administrators can access.
They are listed in the side-bar menu at the left of the Configuration screen. The
following sections discuss the tasks that you can perform on these screens.
Specifying system settings
On the System Settings screen, you can set the date and time, and change the IP
address information for the PCS4. To change the available system settings,
follow these steps:
System Settings screen on the Configuration tab
1.
2.
IP settings
www.camboard.de
4-10
IPL T PCS4 • Web Page-Based Setup and Control
CAMBOARD Electronics
On the Configuration tab, select System Settings from the side-bar menu at
the left edge of the screen. The System Settings screen appears, displaying
either the factory default information for your PCS4, or the settings
submitted most recently.
Enter your new information in the IP Settings section or select the date and
time from the menus in the Date/Time Settings section.
The following settings are available in the IP Settings section:
•
Unit Name: The default is the product name followed by the last six
digits of the MAC address. You can give the unit a new name (such as
"LigntsOn&Off" or "BoardroomA-PCS4") consisting of up to 24
alphanumeric characters including the hyphen (-).
The first character must be an alpha character, and the last
character cannot be a hyphen. The unit name is not case-sensitive.
•
DHCP: DHCP is a communications protocol that assigns addresses
on the local network automatically. Select the On or Off radio button to
enable or disable DHCP.
•
IP Address: You can enter a new network address consisting of four
sets of up to three digits, separated by periods (xxx.xxx.xxx.xxx).
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de
Advertisement
Table of Contents
