Table of Contents
Advertisement
im Vertrieb von
Installation and Rear Panel
Installation Overview
To install and set up an IPL T PCS4 interface, follow these steps:
Turn all of the equipment off. Make sure that the video sources (DSS, cable
1
boxes, or other devices), the IPL interface, the output devices (monitors,
VCRs, projectors, etc.), and the controller are all turned off and disconnected
from the power source.
Mount the PCS4 interface. See Mounting the IPL T PCS4 Interface, below.
2
Plug the PCS4 power cord into an AC outlet. For the 120 VAC
3
version, use the supplied 14 AWG IEC power cord (part #27-407-01).
Connect an active LAN Ethernet cable to the RJ-45 port on the rear panel to establish
4
a link to the network.
Set up an IP address for the PCS4. (See chapter 4, Web Page-Based Setup and
5
Control, or chapter 5, SIS
Plug the desired devices into the power receptacles on the PCS4 rear panel.
6
Press the front panel buttons to power on the receptacles.
7
Turn on the output devices.
8
Configure the PCS4 interface through the front panel, Telnet, or the Web pages,
9
then access the unit using an Internet browser.
Mounting the IPL T PCS4 Interface
The IPL T PCS4 can be set on a table, mounted on a rack shelf, or mounted under
furniture such as a desk, podium, or tabletop.
Tabletop use
Four self-adhesive rubber feet are included with the PCS4. For tabletop use,
attach one foot at each corner of the bottom side of the unit, and place the PCS4
in the desired location.
Rack mounting
Rack mount the interface, if desired, using the included 19" Universal rack shelf
mounting kit.
www.camboard.de
2-2
IPL T PCS4 • Installation and Rear Panel
CAMBOARD Electronics
™
Programming and Control.)
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de
Advertisement
Table of Contents
