Table of Contents
Advertisement
im Vertrieb von
Under-desk mounting
www.camboard.de
CAMBOARD Electronics
Half-rack
false front panel
uses 2 front holes.
IP L
T P
C S
4
R
F
1
F
2
S
F
3
S
F
4
S
S
SE
ST
T R
A N
EF
D B
ER
Y
EN
C E
FU
LL
10 0
LI N
K
AC
T
Mounting the IPL T PCS4 on a 1U Universal rack shelf
1.
If rubber feet have been installed on the bottom of the unit, remove them.
2.
Mount the PCS4 on the rack shelf (part #60-190-01), using two 4-40 x 3/16"
screws in opposite (diagonal) corners to secure the unit to the shelf.
3.
Attach a blank panel or other unit(s) to the rack shelf.
4.
Insert the shelf into the rack, aligning the holes in the shelf with those in the
rack.
5.
Secure the shelf to the rack using the supplied machine screws. This shelf
can be mounted in the front or in the rear of the rack.
The PCS4 can also be mounted under furniture, such as a table or podium
surface, using the optional under-desk mounting brackets (part #70-077-01).
If rubber feet were previously
1.
installed on the bottom of the
unit, remove them.
2.
Attach the mounting brackets to
the unit with the provided
machine screws.
3.
Insert #8 wood screws into the
four pilot holes. Tighten each
screw into the mounting surface
until slightly less than ¼" of the
screw protrudes.
4.
Align the mounting screws with
the slots in the brackets, and
place the PCS4 against the surface with the screws through the bracket
slots.
Slide the unit slightly forward or back, then tighten all four screws to secure
5.
it in place.
Tel. 07131 911201
Fax 07131 911203
(2) 4-40 x 3/16" screws
Use 2 mounting holes on
opposite corners.
ce-info@camboard.de
IPL T PCS4 • Installation and Rear Panel
N
L A
M
A R
A L
X
M A
0 A
D 1
O A
L L
T A
T O
V
4 0
A
0 -2
10
2 0
0- 24
0V
20
Hz
/6 0
50
2-3
Advertisement
Table of Contents
