Installation Overview; Mounting The Interfaces; Tabletop Placement; Under-Desk Mounting - Extron electronics RGB 190F User Manual

Installation and Operation
Installation and Operation, cont'd

Installation Overview

This is an overview of the installation process. You will find
detailed installation and operation instructions in this chapter.
Install and set up the RGB 190F and RGB 192 interfaces
following these basic steps:
Turn all of the equipment (computers, remote controls,
1
interface, projector/monitor, local monitor, and speakers
or other audio device) off. Disconnect the power cords
from the power source.
Install the rubber feet for tabletop use, or install the
2
appropriate brackets and furniture mount the interface.
See Mounting the Interfaces in this chapter.
Connect the input (computer video and audio (RGB 192
3
only)) and outputs (display, local monitor, and audio
(RGB 192 only)). See Connections and Switches in this
chapter.
Set the front panel DIP switches. See Connections and
4
Switches in this chapter as a guide.
Connect power cords and turn on the devices: output
5
devices (projector, monitors, speakers (RGB 192 only)),
interface, and the source computer.
Adjust horizontal centering and set the Level DIP switch
6
to obtain the best picture.

Mounting the Interfaces

Select an installation option: tabletop placement, or under-desk
or through-desk mounting. Follow the appropriate procedure
on the next three pages.

Tabletop placement

For tabletop or desktop placement only, install the self-adhesive
rubber feet/pads (provided) onto the four corners of the bottom
of the interface enclosure.

Under-desk mounting

1. Secure the included under-desk mounting brackets
(part #70-077-01) to the interface with the machine screws
that are already installed in the side of the interface
(figure 2-1).
2-2 RGB 190F, RGB 192 • Installation and Operation
AU
D IO
C O
M P
U T
E R
M O
N IT
O R
Figure 2-1 — Under-desk mounting
2. Hold the interface with attached brackets against the
underside of the desk or other furniture. Mark the
location of holes for screws on the desk.
3. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot
holes in the table or desk at the marked screw locations
from the underside/inside (concealed side) of the
furniture, where the interface will be located.
4. Insert the four wood screws into the pilot holes. Fasten
each screw into the installation surface until just less than
1/4" of the screw protrudes.
5. Align the installed screws with the slots in the mounting
brackets, and place the interface against the surface, with
the screws through the bracket slots.
6. Slide the interface slightly forward or back, then tighten all
four screws to fasten it in place.

Through-desk mounting

1. If rubber feet were installed on the interface, remove them.
2. Insert the machine screws that are already installed in the
side of the interface through the slots in the through-desk
mounting brackets (part #70-077-02), and loosely secure
the brackets to the interface (figure 2-2).
3. Hold the interface with attached brackets against the
underside of the desk/table. With a soft pencil mark the
location of holes for screws on the desk. Mark the
opening, approximately 1.0" x 5.7" ( 2.5 cm x 14.5 cm).
RGB 190F, RGB 192 • Installation and Operation
H -S
H IF
T
SE
RR
L E SO G
V E
L
R G
O N
B 1 DD
NO SP
9 2 M. MO
AU N.
1 DI O
2
3
4
5
6
2-3