Table of Contents
Advertisement
Rack Mounting Procedure
To mount the PC1 on a rack shelf:
1.
2.
3.
4.
5.
Under-desk Mounting
The PC1 can also be mounted under furniture, such as a table or podium surface, using the
optional under-desk mounting kit MBU 125 (see figure 44).
1.
2.
3.
4.
If rubber feet have been installed on the bottom of the unit, remove them.
Mount the PC1 on the rack shelf, using two 4-40 x 3/16 inch screws in opposite
(diagonal) corners of the unit to secure it to the shelf (see
Attach a blank panel or other units to the rack shelf.
RSU 129
1U Universal Rack Shelf
Both front false faceplates
use 2 screws.
Use 2 mounting holes on
opposite corners.
Figure 43.
Mounting the IPL T PC1 on an RSU 129 Universal Rack Shelf
Insert the shelf into the rack, aligning the holes in the shelf with those in the rack.
Secure the shelf to the rack using the supplied machine screws. This shelf can be
mounted in the front or in the rear of the rack.
If rubber feet were previously installed on the bottom of the unit, remove them.
Attach the mounting brackets to the unit with the provided machine screws.
Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting
surface until slightly less than ¼ inch of the screw protrudes.
Align the mounting screws with the slots in the brackets, and place the PC1 against the
surface with the screws through the bracket slots.
IPL T PC1 • Reference Material — Mounting the IPL T PC1
figure 43
1/2 Rack Width Front False
Faceplate
1/4 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
on the next page).
62
Advertisement
Table of Contents
