Fujitsu M10 Product Notes page 71

Table 3-5 Problems that might occur with XCP 2240 and workarounds (continued)
SPARC M10-
RTI No. 1 4 4S
RTIF2- x x x
140304-006
RTIF2- x
140304-007
RTIF2- x x x
140402-001
RTIF2- x x x
140402-003
Description
No error log is registered when any of
the following occurs :
- the power supply (PSU) fails due to
PSU shortage (power off started), PSU
shortage, and the wrong PSU is
installed.
- if the errors re-occur on the PSU of the
same chassis.
- after active replacement or hot
replacement of the PSU by the
replacefru(8) command
When the power supply unit (PSU) fails
due to any of the following errors, and
after active replacement or hot
replacement of the PSU by the
replacefru(8) command, if any of the
following errors re-occur on the PSU of
the same chassis, no error log is registered.
- PSU shortage (power off started)
- PSU shortage
- Wrong PSU is installed
When replacing power supply units
(PSUs) with the replacefru(8) command,
if the [f] key in the menu of the
replacefru(8) command is pressed within
30 seconds after mounting the new PSU,
any problem in the new PSU cannot be
detected.
The following special characters cannot
be included in the mail address input
field for the [Settings] - [Service] -
[SMTP], [Settings] - [Email Reporting],
[Settings] - [Audit], and [Settings] -
[CoDActivation] menus on the XSCF We
b.
"!" "#" "$" "%" "&" "'" "*" "+" "/" "=" "?" "^"
"`" "{" "|" "}" "~"
When using XSCF Web in Internet
Explorer, if you attempt to delete the
second and subsequent User/Group
settings of [Groups] and [View Access] of
VACM in the [XSCF] - [Settings] -
[Service] - [SNMP Security] menu, an
error message is output and the deletion
cannot be executed.
Workaround
Execute the replacefru(8) command to
perform cold replacement if a PSU is
replaced for the first time after any of the
error logs shown in [Description] is
registered. In such a case, do not perform
active replacement or hot replacement.
See "Workaround for RTIF2-140304-007".
Use the setemailreport(8) command of
the XSCF shell.
Execute the deletion by using XSCF Web
in Firefox or the setsnmpvacm(8)
command of the XSCF shell.
Chapter 3 Information on Software 57