Fujitsu M10 Product Notes page 127

Table 3-12 Problems resolved in XCP 2210 (continued)
SPARC M10-
RTI No. 1 4 4S
RTIF2- x
140407-007
RTIF2- x x x
140410-001
RTIF2- x
140410-007
RTIF2- x x x
140507-
019
RTIF2- x
140507-020
Description
After a degraded system board is
replaced using the replacefru(8)
command, the replacement system board
is diagnosed using the replacefru(8)
command menu or the testsb(8)
command. The diagnosis fails if all of the
following conditions are met.
- Physical partition (PPAR) consists of
multiple system boards and the PPAR
power is on.
- Some system boards in the PPAR are
stopped through degradation.
An XSCF NTP server function may be
used as the platform for a DDoS attack
(CVE-2013-5211).
When setting the takeover IP address
(virtual IP address) for the XSCF
network, the XSCF-LAN IP address
(physical IP address) needs to be set for
both master and standby XSCFs.
Otherwise, the takeover IP address
setting may not be reflected after the
setting is applied and XSCF is reset.
If Firefox 26 is used in an environment
with XSCF firmware older than XCP
2210, the frame of the pop-up window
appears in thick black line.
If the master XSCF is switched to standby
state just after executing the "poweroff -f
-p -n" (n is partition number) command,
the following message is registered in the
error log, displayed by the "showlogs
error" command.
Msg: SCF process down detected
Workaround
Use either of the following procedures to
replace a system board and execute
diagnosis.
1. Before replacing the system board,
execute the deleteboard(8) command to
change the system board state to
system board pool (SP).
2. After completing system board
replacement and diagnosis, execute the
addboard(8) command to assign the
system board to PPAR again.
Or
1. After powering off the PPAR, execute
system board replacement and
diagnosis.
[How to restore]
After executing the deleteboard(8)
command to change the system board
state to system board pool (SP) or after
powering off the PPAR, redo the system
board diagnosis.
Update the XCP firmware version to XCP
2210 or later.
Set the XSCF-LAN IP address (physical
IP address) of both master and standby
XSCFs and then set the takeover IP
address.
Ignore the thick black frame.
There is no effective workaround.
This symptom has no effect on the
system operation.
Chapter 3 Information on Software 113