Restrictions On Adding Expansion Rack 2; Problems With Hardware And Workarounds - Fujitsu M10 Product Notes

XSCF> showlogs error
9.
Confirm that there are no faulty components.
XSCF> showstatus

Restrictions on adding expansion rack 2

Addition of a crossbar box using the addfru(8) command is not supported at present.
To add a crossbar box, see the "9.4 Installing Expansion Rack 2" in the Fujitsu
M10/SPARC M10 Systems Installation Guide and read Steps 17 and 18 as follows:
17. Connect all power cords of the crossbar box and SPARC M10-4S to the input
power supply.
For details, see "5.2 Connecting Cable to SPARC M10-4/SPARC M10-4S" and "5.4
Connecting Cable to Crossbar Box."
18. Update the firmware to the same version as the master XSCF.
XCP 2040 or earlier
■
XSCF> getflashimage file:///media/usb_msd/images/XCPxxxx.tar.gz
XSCF> flashupdate -c update -m xcp -s version
XCP 2041 or later
■
XSCF> flashupdate -c sync
Problems with Hardware and
Workarounds
There is no problem that has been confirmed as of this moment.
Chapter 6 Information on SPARC M10-4S Hardware 185