Fujitsu M10 Product Notes page 123

Table 3-12 Problems resolved in XCP 2210 (continued)
SPARC M10-
RTI No. 1 4 4S
RTIF2- x
140212-001
RTIF2- x x x
140212-010
Description
In a system configuration with several
SPARC M10-4S (system boards), after a
system board in a physical partition has
been degraded due to failure, when the
system board is attempted to be replaced
with the replacefru(8) command, the
system board is recognized as being
running and the attempt of replacement
fails with the following error message:
[Warning:028]
BB#XX cannot be replaced because the
PSB in the BB that you indicated is
running.
Similarly, an attempt to initialize the
degraded system board with the initbb(8)
command fails with the following error
message:
Hardware error occurred by initial
diagnosis.
This symptom occurs if the system board
is in the following state, when the
showhardconf(8) or the showboards(8)
command is executed:
[Example]
In case PSB#01-0 (BB#01) has been
degraded.
XSCF> showhardconf
...
* BB#01 Status:Deconfigured;
...
XSCF> showboards -a
PSB PPAR-ID(LSB) Assignment Pwr
Conn Conf Test Fault
--- ------------ ----------- ---- ---- ---- -------
--------
01-0 00(01) Assigned
n Passed Faulted
If [Ctrl]+[C] is executed in the middle of
executing the setsnmp(8), setsnmpusm
(8) or the setsnmpvacm(8) commands,
SNMP cannot be set up using the above
commands after that. In such a case, the
error message "configuration being
changed by another user" may be
displayed.
Workaround
After removing the degraded system
board from the physical partition with
the deleteboard(8) command, execute
either the replacefru(8) or the initbb(8)
command to replace or remove the
system board.
[Example]
XSCF> deleteboard -c unassign 01-0
After replacing the system board, assign
the system board to the physical partition
using the addboard(8) command and
follow the maintenance procedures to
add it in the physical partition.
[Example]
XSCF> addboard -c assign -p 0 01-0
n n
There is no effective workaround.
Chapter 3 Information on Software 109