Fault Code Source - Genie ZX-135/70 Service And Repair Manual

Service and Repair Manual
Fault Codes
Fault Source and Type will display as:
Source
" ID XXX_xx FAULT "
Where XXX is the one to three digit Fault Source
and xx is the two digit Fault Type.
TCON - Turntable Controller
PCON - Platform Controller
SCON - Safety Controller
DCON - Drive Controller
Fault Type
ID Description
11 Value at 5V
12 Value too High
13 No Response
15 Value too Low
16 Value at 0V
17 Not Calibrated
21 Fault
26 Timeout
31 Invalid Setup
32 Min Cal Too Low
33 Min Cal Too High
156
Type
ZX®-135/70
Fault Source
ID Description
3 SCON Controller Area Network
4 Primary Boom Angle Zone
5 Primary Boom Length Switches Cross-Check
8 PCON Controller Area Network
9 Engine
18 DCON Controller Area Network
20 Boom Extend/Retract Joystick
21 Boom Up/Down Joystick
26 Boom Extend/Retract Buttons
27 Boom Up/Down Buttons
28 Boom Angle Sensors Cross-Check (SCON)
29 LSB2RS/LSB4ES Cross-Check (SCON)
30 Propel Joystick
35 Propel Valve
40 Turntable Rotate Joystick
43 Footswitch Timeout
44 Jib Up/Down Joystick
48 PBMAS Safety Envelope (SCON)
49 Jib Up/Down Buttons
50 Jib Up/Down Flow Valve
52 Steer Joystick
53 Left Front Steer Sensor
54 Right Front Steer Sensor
55 Left Rear Steer Sensor
56 Right Rear Steer Sensor
59 Rocker Steer Joystick
61 PBMLS Safety Envelope (SCON)
63 Front Axle Sensor
64 Rear Axle Sensor
April 2018
Part No. 1279835GT