NETGEAR ProSafe WG302 Reference Manual page 4

Antenna Statement for North America and Australia
In addition to its own antenna, the WG302 device has been approved for use with the following detachable antennas and
.
antenna cables.
Approved Antenna Gain and
Antennas type
NETGEAR 14 dBi, directional
ANT24D18 outdoor/indoor
NETGEAR 8.5 dBi,
ANT2409 omnidirectional
outdoor/indoor
NETGEAR 5 dBi, ceiling/wall
ANT24O5 indoor
a. WG302 maximum radiated power in North America and Australia: 19 dBm ñ cable loss + antenna gain
www.netgear.com/go/wg102_fcc
Please go to
the WAG302 in North America and Australia.
Industry Canada Compliance Statement
This Class B Digital apparatus meets all the requirements of the Canadian Interference Causing Equipment Regulations
ICES 003.
Cet appareil numerique de classe B respecte les exigences du reglement du Canada sur le materiel brouilleur NMB-003.
The device is certified to the requirements of RSS-210 for 2.4 GHz spread spectrum devices. The use of this device in a
system operating either partially or completely outdoors may require the user to obtain a license for the system according
to the Canadian regulations. For further information, contact your local Industry Canada office.
IC statement
Operation is subject to the following two conditions:
1) This device may not cause interference and
2) This device must accept any interference, including interference that may cause undesired operation of the device.
This device has been designed to operate with an antenna having a maximum gain of 4.59352 dBi. Antenna having a
higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must
follow the specific operating instructions for satisfying RF exposure compliance. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
iv
Approved Antenna
Cable
NETGEAR ACC-10314-
01 thru 05
NETGEAR ACC-10314-
01 thru 05
NETGEAR ACC-10314-
01 thru 05
for an updated list of wireless accessories approved to be used with
v0.1, December 2005
Antenna Cable
Length
30 m
10 m
NA