Getting Help On Commands At The Cli - NETGEAR ProSafe WG302 Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG302
remove
The CLI also includes the following commands for maintenance tasks:
save-running
reboot
factory-reset

Getting Help on Commands at the CLI

Help on commands can be requested at the command line interface (CLI) by using the TAB key.
This is a quick way to see all valid completions for a class.
Hitting TAB once will attempt to complete the current command.
If multiple completions exist, a beep will sound and no results will be displayed. Enter TAB again
to display all available completions.
At a blank command line, hit TAB twice to get a list of all commands.
Example 1:
NETGEAR-AP#
add Add an instance to the running configuration
factory-reset Reset the system to factory defaults
get Get property values of the running configuration
reboot Reboot the system
remove Remove instances in the running configuration
save-running Save the running configuration
set Set property values of the running configuration
Type "get" <TAB><TAB> (including a space after get) to see a list of all property
Example 2:
options for the get command.
NETGEAR-AP# get
association
basic-rate
bridge-port
bss
C-6
The "remove" command allows you to remove an existing instance of a class.
remove unnamed-class [property value...]
remove named-class instance | all [property value...]
For example:
remove radius-user wally
save-running
The
startup configuration.
The reboot command restarts the access point (a "soft" reboot).
factory-reset
The
reboots.
Associated station
Basic rates of radios
Bridge ports of bridge interfaces
Basic Service Set of radios
v0.1, December 2005
command saves the running configuration as the
command resets the AP to factory defaults and
Command Line Reference