Hardware Description; Front Panel - NETGEAR ProSafe WG302 Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG302

Hardware Description

This section describes the WG302 front and rear hardware functions.

Front Panel

Figure 2-1
Viewed from left to right, the WG302 has these status LEDs: PWR, TEST, LAN, and 802.11g
WLAN.
LED Description
PWR Power Indicator
Off
On
TEST Self Test Indicator
Blink
LAN Ethernet link indicator
Off
Amber On
Amber Blink
Green On
Green Blink
Introduction
No power. If this LED does not come on with the power adapter and
cord correctly installed, see
Power is on.
Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going off.
No connection detected on the Ethernet link
10 Mbps Ethernet link detected
Data is being transmitted or received on the 10 Mbps Ethernet link
100 Mbps Fast Ethernet link detected.
Data is being transmitted or received on the 100 Mbps Ethernet link
v0.1, December 2005
Chapter 6, "Troubleshooting.
2-7