Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG302
Note: When configuring the WG302 from a wireless computer whose MAC address
is not in the access control list, if you select Turn Access Control On, you will
lose your wireless connection when you click Apply. You must then access the
wireless access point from a wired computer or from a wireless computer
which is on the access control list to make any further changes.
2. From the Security menu, click the Access Control link to display the Access Control List
(ACL) menu shown below.
Figure 3-12
3. Select the Turn Access Control On check box.
4. Choose to use the local MAC address database stored on the access point, or use the RADIUS
MAC address database stored on a RADIUS server.
•
If you choose the RADIUS MAC Address Database, you must configure the RADIUS
Server Settings first.
•
If you choose Local MAC Address Database, either select from the list of available
wireless cards the WG302 has found in your area, or enter the MAC address and device
name for a device you plan to use.
3-22
v0.1, December 2005
Basic Installation and Configuration