Multi-Point Bridge Configuration - NETGEAR ProSafe WG302 Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG302

Multi-Point Bridge Configuration

Set up a Multi-Point Bridge only if this WG102 is the "master" for a group of bridge-mode
wireless stations. Then all traffic is sent to this "master," rather than to the other access points. In
addition, you can enable client associations with this WG302.
• You must enter the MAC addresses of the other access points in the fields provided.
• The other bridge-mode wireless stations must be set to Point-to-Point Bridge mode, using the
MAC address of this WG102 as the Remote MAC Address.
• Use WEP to protect this traffic.
The figure below shows an example of a Multi-Point Bridge mode configuration.
Point-to-Multi-Point
Bridge mode
Router
Internet
192.168.0.1
LAN Segment 1
Figure 5-8
Follow the steps below to set up the Multi-Point Bridge configuration.
1. Configure the Operating Mode of the WG302 Wireless Access Points.
• Because it is in the central location, configure WG302 (AP 1) on LAN Segment 1 in
Point-to-Multi-Point Bridge mode. The MAC addresses of AP2 and AP3 are required in
AP1.
• Configure WG302 (AP 2) on LAN Segment 2 in Point-to-Point Bridge mode with the
Remote MAC Address of AP1.
Advanced Configuration
"Master AP"
AP 1
Point-to-Point
Bridge Mode
PCs
v0.1, December 2005
Point-to-Point
Bridge Mode
AP 2
Hub or Switch
PCs
LAN Segment 2
AP 3
Hub or Switch
PCs
LAN Segment 3
5-11