NETGEAR ProSafe WG302 Reference Manual page 109

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG302
config
detected-ap
dhcp-client
dot11
host
interface
ip-route
log
log-entry
mac-acl
ntp
portal
radio
radius-user
serial
snmp
ssh
static-ip-route
supported-rate
system
telnet
traphost
tx-queue
wme-queue
Type get system v TAB. This results in completion with the only matching
Example 3:
property, get system version. Press ENTER to display the output results of the command.
Command Line Reference
Configuration settings
Detected access point
DHCP client settings
IEEE 802.11 (all radios)
Internet host settings
Network interface
IP route entry
Log settings
Log entry
MAC address access list item
Network Time Protocol client
Guest captive portal
Radio
RADIUS user
Serial access to the command line interface
SNMP (Simple Network Management Protocol)
SSH access to the command line interface
Supported rates of radios
System settings
Telnet access to the command line interface
Destination host for SNMP traps
Transmission queue parameters
Transmission queue parameters for stations
v0.1, December 2005
C-7