Wireless Settings - NETGEAR ProSafe WG302 Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG302
• IP Subnet Mask. Enter the subnet mask value used on your LAN (factory default:
255.255.255.0).
• Default Gateway. Enter the IP address of the Gateway for your LAN. For more complex
networks, enter the address of the router for the network segment to which the wireless access
point is connected (factory default: 0.0.0.0).
• DNS Server. Enter the IP address of the DNS (Domain Name Server) you wish to use (factory
default: 0.0.0.0.
• Enable 802.1Q VLAN. Check the box Enable 802.1Q VLAN to enable the WG302 to process
VLAN membership information.
• Time Zone. Select the Time Zone to match your location. If your location uses daylight
saving, check the box Adjust for Daylight Saving Time.
• The Current Time, as used on the wireless access point, is displayed.
Note: You must have an Internet connection to get the current time.

Wireless Settings

To configure the wireless settings, click Wireless Settings in the Setup section of the WG302 main
menu. The Wireless Settings menu appears, as shown in
Figure 3-8
Basic Installation and Configuration
Figure
v0.1, December 2005
3-8.
3-11