Using The Reset Button To Restore Factory Default Settings - NETGEAR ProSafe WG302 Reference Manual

Reference Manual for the NETGEAR ProSafe 802.11g Wireless Access Point WG302

Using the Reset Button to Restore Factory Default Settings

The Reset button (see
• Reboot. When pressed and released quickly, the WG302 will reboot (restart).
• Reset to Factory Defaults. This button can also be used to clear ALL data and restore ALL
settings to the factory default values.
To clear all data and restore the factory default values:
1. Power off the WG302 and power it back on.
2. Use something with a small point, such as a pen, to press the Reset button in and hold it in for
at least 5 seconds.
3. Release the Reset button.
The factory default configuration has now been restored, and the WG302 is ready for use.
6-4
"Rear Panel" on page
v0.1, December 2005
2-8) has two functions:
Troubleshooting