Toshiba Tosvert VF-S15 Instruction Manual page 145

 Setting of switching terminals
To switch to motor 2, assign the following functions to a terminal not being used. It is also possible to switch
to acceleration/deceleration 2 (AD2). Refer to section 6.27 for details.
It is possible to set 3 functions for terminal F and R, and 2 functions for terminal S1 and RES.
Input terminal function number
24 26
AD2 AD3
OFF OFF
ON OFF
OFF ON
OFF OFF
OFF OFF
6
- OFF
Note 1: Each of the following numbers (25, 27, 29, 33, 153) are reverse signals.
Note 2: pt and "V/F constant" cannot be switched while running. Stop the motor before switching.
Note 3: If motor is switched, the setting to retain and subtract an integral value of motor electronic thermal is possible.
 Example of setting a terminal for switching: Sink logic
28 32 152
VF2 OCS2 MOT2
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
OFF ON OFF
- - ON
After the change, please drive after 0.2 seconds or more.
vl and f170, vlv and f171, vb and f172 can be switched while running.
Refer to section 5.6 for details.
F (F: Forward run)
CC
S1(AD2)
S2(VF2)
S3(OCS2)
Parameters changed from applicable parameters and
default standards
Default setting :
acc→ fs00, dec→ f501, f502→fs03
acc→fs10, dec→f511, f502→fs12
During stop : pt→V/F constant , vl→f170,
vlv→f171, vb→f172,
thr→f173
During run : vl→f170, vlv→f171, vb→f172
f601→f185
→, →, → , →,
→( is fixed when = or ),
→, →, →,
→
Forward run command
2nd acceleration/deceleration switch
2nd V/F setting switch
2nd stall prevention operation switch
F-34
E6581926
pt, vl, vlv, vb, thr,
acc, dec, fs02, f601