Toshiba Tosvert VF-S15 Instruction Manual page 125

:
:
:
1
4:
● The control input terminal in which the following functions are set is always valid regardless of the setting of
 and .
 Reset (valid only for tripping)
 Standby
6
 External input tripping stop command
 Coast stop command terminal
● To make changes in the command mode selection  and the frequency setting mode selection 1
, first stop the inverter temporarily.
(Can be changed while in operation when  is set to .)
● Priority commands from communications or terminal blocks are given priority over .
 Preset-speed operation
: Set to  (Terminal block operation)
: Valid in all setting values.
 Input terminal settings
Assign the following functions to the input terminal to allow switching of the frequency command by turning
the terminal ON/OFF.
48
106
Each of the following numbers (49, 107) are reverse signals.
Communication Frequencies are set by commands from a communication option.
option
 Refer to each Instruction Manual of option.
A frequency command is set by means of external analog signals.
Terminal VIC
(VIC terminal: 0 (4) - 20mAdc)
 Refer to section 3.1.2 and 7.3
A frequency command is set by means of external pulse train signals.
Pulse train input (S2 terminal: 10pps - 2kpps)
 Refer to section 6.10.5
Frequencies are set by sro parameter.
sro
 Refer to section 5.7
Input terminal function
Forced local from communication
Frequency setting mode terminal
block
ON
Enabled during communication
Local (Setting of , )
Terminal block (VIA) enabled
F-14
E6581926
OFF
Communication
setting of 