Adjusting Footplate Height - Invacare Concept 45 User Manual

5.2

Adjusting Footplate Height


This procedure applies to the swingaway front riggings and swingaway elevating legrest.
1. Remove the front rigging. Refer to Installing/Removing Front Riggings on page 34.

Lay the front rigging assembly on a flat surface to simplify this procedure.
2. Loosen, but do not remove, the hex head screw and locknut securing the footplate assembly to the legrest tube.
3. Adjust the footplate assembly height by aligning the desired height.
4. Securely tighten the hex head screw and locknut securing the footplate assembly to the legrest tube.
5. Reinstall the front rigging. Refer to Installing/Removing Front Riggings on page 34
6. Repeat STEPS 1-5 to adjust the remaining footrest.
Hex Head Screw
Part No. 1088191
Legrest Tube
Footplate Assembly
and Locknut
FIGURE 2 Adjusting Footplate Height

Swingaway footrest shown.
35
5 FRONT RIGGINGS
®
Invacare Concept 45 Wheelchair