Installing Angle Adjustable Footplate; Adjusting The Legrest Angle; Adjusting The Footplate Height - Invacare Action3 Junior Service Manual

Installing Angle Adjustable Footplate

NOTE: For this procedure, refer to FIGURE 2.4.
NOTE: This procedure is for individual Angle Adjustable Footrests only.
1. Position the angle adjustable footplate on the footrest support tube at the desired
height.
2. Using the locking screw, loosely secure the angle adjustable footplate to the
footrest support tube.
NOTE: Refer to Adjusting Footrest Height paragraph.
3. Using the mounting screw, adjust to the desired angle (Tooth Plates) by rotating the
footplate and depth by sliding the footplate into the tooth plates support.
4. Using the mounting screw (M6), secure the Angle Adjustable Footplate to the
footrest tube. Securely tighten.
5. If necessary, repeat STEPS 1
Mounting Screw (M6)
Adjusting Elevating Legrest Angle, Footplate
height/angle and Calf pad Height
NOTE: For this procedure, refer to FIGURE 2.5.
Ad justing the Legrest Angle
1. Loosen Locking Knob securing the rotating axle of the elevating legrest.
2. Adjust to desired angle, firmly tighten Locking Knob.
3. If necessary, repeat STEPS 1-2 to adjust remaining elevating legrest angle.
Ad justing the Footplate Height
1. Loosen Knob securing the slide tube to the elevating legrest.
2. Adjust into one of preset positions and firmly tighten the Knob (5 Nm).
3. If necessary, repeat STEPS 1
4 to adjust remaining Angle Adjustable Footplate.
-
FIGURE 2.4 Installing Angle Adjustable Footplate
2 to adjust remaining footplate height.
-
SECTION 2—FRONT HANGERS
Tooth Plates
Angle Ajustable Footplate
9