Invacare Concept 45 User Manual page 50

10 ANTI-TIPPERS/WHEEL LOCKS
Installing Anti-Tippers

The anti-tipper bracket is located on the axle mounting bracket.
1. Press the release buttons and insert the anti-tippers with the
anti-tipper wheels pointing toward the ground/floor into the
anti-tipper bracket.
2. Ensure that the release button of the anti-tipper fully protrudes out
of the hole in the bottom of the wheelchair frame tubing.
3. Place the wheelchair on a flat surface.
4. Measure the distance between the bottom of the anti-tipper wheels
and the ground/floor.
 A 1-1/2 to 2 inch clearance between the bottom
of the anti-tipper wheels and the ground/floor
MUST be maintained at all times.
5. If the distance between the bottom of anti-tipper wheels and the
-1/2
ground/floor is not 1
Adjusting the Anti-Tippers on page 51.
®
Invacare Concept 45 Wheelchair
to 2 inches, adjust anti-tippers. Refer to
Anti-Tipper
Release Buttons
Anti-Tipper Wheels
FIGURE 1
50
Axle Mounting Bracket
Anti-Tipper Bracket
Installing Anti-Tippers
Part No. 1088191