Table of Contents
Advertisement
7.3
Adjusting Footplate Height
Spring Button
This procedure applies to the swingaway front riggings and swingaway elevating legrest.
1.
Remove the front rigging assembly. Refer to Installing/Removing Front Riggings on page 35.
Lay the front rigging assembly on a flat surface to simplify this procedure.
2.
Pull the cam lock lever up to unlocked position.
The elevating legrest has two sets of release
buttons, one set above the other. Each set will be
visible one at a time allowing finer footplate height
adjustment.
3.
Push in the release buttons and reposition the footplate assembly
to the desired height.
4.
Ensure that the release buttons fully protrude from holes on both
sides of the front rigging support.
5.
Rotate cam lock lever down to locked position.
6.
Repeat this procedure for the other footplate, if necessary.
7.
Reinstall the swingaway front rigging assembly. Refer to
Installing/Removing Front Riggings on page 35.
Part No. 1110550
Adjustment
Holes
Cam Lock Lever
Swingaway footrest
shown
FIGURE 3
Adjusting Footplate Height - Spring Button
53
7 ADJUSTMENT
Front Rigging Support
Release Button
Footplate
Assembly
Invacare® Tracer® SX5 Wheelchair
Advertisement
Table of Contents
