Preparation For Use, Storage Or Shipping; Preparation For Use - Hobart 60CU20 Operation And Maintenance Manual With Illustrated Parts List

OM-2226 / Operation and Maintenance Manual
60CU20 / Series 500062 / 400 Hz. Generator Set
Section 2

1) Preparation for Use

a) Inspection/Check
Inspect the unit thoroughly prior to operation.
(1) Remove blocking, banding, ties, and other securing material.
(2) Inspect exterior for shipping damage such as broken lights, damaged sheet metal, etc.
(3) Open all canopy doors and inspect interior for foreign material such as rags, tools, shipping
papers, etc.
(4) Check fuel, coolant, oil hoses and connections for visible leaks. Visually inspect the compartment
floor and ground surface under the unit for signs of leakage. Correct any leaks by tightening hose
clamps, tube fitting, etc., as required.
(5) Check security of generator set retaining components.
(6) Check the fuel level. Press the LAMPS pushbutton switch to energize the fuel gauge when the
engine is stopped. Fuel is supplied from a customer-furnished source.
NOTE: For recommended fuel specifications, refer to the Engine Manufacturers Operation and
Maintenance Manual provided with this manual.
(7) Check the engine coolant. Remove the radiator cap to check coolant level. Coolant level should
be at the bottom of the filler neck.
CAUTION
Be sure the cooling system antifreeze solution is adequate to protect below the lowest
temperature expected.
NOTE: For antifreeze protection, use a solution of 50% permanent antifreeze (Ethylene glycol)
and 50% clean water.
Lubricating oil capacity (w/ filter)
Coolant capacity system
May 2, 2013
Preparation for Use, Storage, or Shipping
Figure 1: Engine Oil and Coolant Capacities
11.6 quarts (11 liters)
20 quarts (18.9 liters)
Chapter 1-2
Page 1