OM-2226 / Operation and Maintenance Manual
60CU20 / Series 500062 / 400 Hz. Generator Set
d
Check the shaft for any damage or deformation where the coupling was mounted on it.
e
Check rubber bushing alignment to make sure that the dimension illustrated in Figure 4 is
maintained.
1. Bolt, 3/8-16 UNC (3)
2. Taper Lock Bushing
3. Taper Lock Hub
4. Tapped holes (2)
May 2, 2013
5. Key
6. Set Screw
7. Fan/Coupling Disk
8. Armature Shaft
Hub and Bushing
Figure 3
Chapter 3-2
Page 3