Coupling Service - Hobart 60CU20 Operation And Maintenance Manual With Illustrated Parts List

OM-2226 / Operation and Maintenance Manual
60CU20 / Series 500062 / 400 Hz. Generator Set

3) Coupling Service

When ordering coupling kits from Hobart Ground Systems or an authorized distributor, be sure to include
all pertinent information from the unit's identification plate (i.e. Specification No., Model No., and unit
rating).
If you have any questions concerning your ITW GSE Group equipment, immediately contact our Service
Department by mail, telephone, e-mail, or FAX.
Write:
Call Inside U.S.A.:
Call From Foreign Countries:
FAX Inside U.S.A.
FAX From Foreign Countries:
E-Mail :
Web Page :
a) Replacement Coupling Kit
A replacement coupling kit is available from your Hobart Ground Systems. The kit provides a
replacement coupling assembly with attaching hardware and installation instructions.
b) Bushing Kit
A bushing kit is available from the Hobart Ground Systems for replacing the rubber bushing only in
the coupling assembly. However, it should be noted that the finished coupling assembly must be
balanced to 1/2 inch-ounce (360 mg-m) minimum. If bushing replacement only is required, the kit
part number is 480290. Each kit contains the required number of bushings, a container of lubrication,
and installation instructions.
c) Bushing Replacement
To replace bushings only, proceed as follows:
(1) Press out all old bushings.
(2) Refer to Figure 4. Clean each bushing socket thoroughly, removing all traces of old rubber. DO
NOT scratch or deform the bore of the bushing socket.
May 2, 2013
Hobart Ground Systems
Service Department
11001 US Highway 41, North
Palmetto, FL 34221
U.S.A.
(800) 899-1841 (Parts)
(877) 874-5322 (Service)
(941) 721-1025 (Parts)
(941) 721-1092 (Service)
(800) 367-4945
(937) 332-5121
service@hobartsystems.com
www.hobartsystems.com
Chapter 3-2
Page 4