Table of Contents
Advertisement
OM-2032 / Operation and Maintenance Manual
100D20 / Generator Sets
Section 2. Preparation for Use, Storage, or Shipping
1. Preparation for Use
a. General
WARNING
b. Inspection/Check
Inspect the unit thoroughly prior to installation or use.
(1) Remove blocking, banding, ties, and other securing material.
(2) Inspect exterior for shipping damage such as broken lights, damaged sheet metal, etc.
(3) Open all canopy doors and inspect interior for foreign material such as rags, tools, shipping
paper, etc.
(4) Check fuel, oil bases, and connections for visible leaks. Visually inspect the compartment floor
and ground surface under the unit for signs of leakage. If leaks are found, correct by tightening
hose clamps, tube fittings, etc., as required.
(5) Check the following for sufficient quantity:
a. Fuel
Turn ON panel lights to energize fuel gage when engine is stopped.
b. Engine lubricating oil
Oil level should be at "FULL" mark on oil level gage rod (Fig. 1) .
(6) Check air cleaner
The air cleaner (Sec. 1-1, Fig. 5) is a "dry" type. Be sure there are no papers, tapes, or other
material covering the air inlet area.
(7) Check batteries
Two 12-VDC batteries are provided in the decking of the trailer.
March 31/94 Revised
Improper operation can kill, injure or damage! Before operating the unit. read
and follow operating instructions in section 1-3
Chapter 1-2
Page 1
Advertisement
Table of Contents
