Replacing A Memory Module - HP FlexNetwork HSR6802 Installation Manual

Figure 60 Memory module structure (DDR3)
(1) Connector edge
(3) Latch notch

Replacing a memory module

The methods for replacing memory modules are similar. This example replaces a memory module
on an RSE-X2.
To replace a memory module:
1. Pull the release latches away from the memory module at both ends so that the memory
module is lifted from the memory module slot.
2. Holding the non-conductive edge, remove the memory module.
3. Align the polarization notch of the memory module with the key in the connector.
4. Insert the memory module into the slot.
5. Carefully and firmly press the memory module at both ends until you hear a click. This indicates
the memory module is seated in the memory module slot.
6. Verify that the release latches have firmly locked the memory module in position.
Figure 61 Replacing a memory module
(2) Polarization notch
50