Replacing An Mpu; Replacing An Sfe-X1 - HP FlexNetwork HSR6802 Installation Manual

•
If the router is installed with two MPUs, make sure both MPUs operate correctly before
replacement.
As a best practice to replace the active MPU, execute the slave switchover command in the
system view of the active MPU to trigger an active and standby switchover. For more
information about the slave switchover command, see HPE FlexNetwork HSR6800 Routers
High Availability Command Reference.
To replace the standby MPU, you can remove it immediately.

Replacing an MPU

The replacement procedures for the RSE-X2 and RSE-X3 MPUs are the same. The following
example uses an RSE-X2.
To replace an MPU:
1. Face the front of the router and locate the MPU to be removed.
2. Use a Phillips screwdriver to completely loosen the captive screws of the MPU.
3. Holding the ejector levers of the MPU with both hands, pull the ejector levers outward, and
gently pull the MPU out of the slot along the slide rails.
Figure 47 Pulling the RSE-X2 MPU out of the slot
4. Install a new MPU. For the installation procedure, see
If you do not install a new MPU in the slot, install a filler panel.

Replacing an SFE-X1

1. Face the front of the router and locate the SFE-X1 to be removed.
2. Use a Phillips screwdriver to completely loosen the captive screws on the SFE-X1.
3. Holding the ejector levers of the SFE-X1 with both hands, pull the ejector levers outward, and
gently pull the SFE-X1 out of the slot along the slide rails.
"Installing an
42
MPU."