Audio Generation-Related Commands - Teledyne 980 DP1.4 User Manual

980 DP 1.4 Video Generator / Analyzer - User Guide
OUTG
Command supported?: Y
Sets the enable gate of video output. (This is defaulted to 1 – only set to 0 to disable video when absolutely necessary.)
Requires FMTU or ALLU to activate.
Query returns the current setting for the enable gate for the video.
Example:
OUTG 1 // enables the outputs.
OUTG? // returns the current setting.
REDG/GRNG/BLUG
Command supported?: Y
Enables red/green/blue, respectively. (Also see XVSG.)
Requires FMTU or ALLU to activate.
Query returns the current setting for enabling red, green, blue video.
Examples:
REDG 1 // enables the red output channel.
GRNG 0 // disables the green output channel.
BLUG 1 // enables the blue output channel.
BLUG? // returns the current setting.
SCAN
Command supported?: Y
Sets the current format to either progressive (SCAN 1) or interlaced (SCAN 2).
Requires FMTU or ALLU to activate.
Query returns the current setting for the scan type.
Example:
SCAN 1 // sets the output to progressive.
SCAN? // returns the current setting.
XVSI
Command supported?: Y
Sets the video interface of the unit.
Requires FMTU or ALLU to activate.
Query returns the current interface activation setting.
Examples:
XVSI 2 // Sets DVI Computer formats
XVSI 3 // Sets DVI TV formats
XVSI 4 // Sets active interface to HDMI

14.2 Audio Generation-Related commands

Refer to the following table lists the audio related commands for generation.
DASI
Command supported?: Y
Sets the digital audio signal interface.
Requires FMTU or ALLU to activate.
Valid values are:
Page 303
Query supported?: Y
Query supported?: Y
Query supported?: Y
Query supported?: Y
Query supported?: Y
Rev. A1
June 16, 2017