Command Line Conventions - Teledyne 980 DP1.4 User Manual

980 DP 1.4 Video Generator / Analyzer - User Guide
The dp-scope>asss prompt is presented as shown above. Note that Slot 6 become the "default" slot and does
not need to be entered on the command line; it is optional.

15.2 Command Line Conventions

Since the 980 can be equipped with multiple modules, there is a convention for addressing commands to specific
modules.
The addressing convention is as follows:
<IN/OUT><Slot><Port>: command_string
The configuration used in this example is a 980 DP 1.4 Video Generator / Analyzer module in Slot 6.
Example: Load a test pattern for the transmitter port (Tx1 port 0) on the 980 DP 1.4 Video Generator / Analyzer
module which is equipped in Slot 6:
OUT60:IMGL SMPTEBar
If you are using the second Tx port (Tx2):
OUT61:IMGL SMPTEBar
If the Rx port is active the Tx1 port will not be available and you will receive an error (below). In this case you will
have to use Tx2.
#dp-scope>out60:fmtu?
ERROR: Invalid Command: ¥out60:fmtu?
rxhprime: DP HDCP2 set hprime in rxstatus
rxlnkfail: DP HDCP2 set link integrity failure in rxstatus
rxpair: DP HDCP2 set pair in rxstatus
Note 2: Commands are not case sensitive.
Page 299
Rev. A1
June 16, 2017